Riso ComColor X1 series Technical Manual page 310

Ink Flow Section
BP Elevation Motor
1) Remove the left and right top covers. (Refer to the section on covers in Chapter 2.)
2) Remove the operation panel (the entire bracket; round tip IT3C screw 4x8 (3 pcs)) and rest it on the left side
of the ink cartridge unit.
3) Open the ink cartridge holder unit.
4) Remove the right front cover and the center and right inner covers. (Refer to the section on covers in Chapter 2.)
5) Remove the right rear cover and side cover. (Refer to the section on covers in Chapter 2.)
6) Manually lower the BP unit to the lower limit position.
7) Put the controller PCB box in maintenance position.
8) Remove the paper elevation motor. (Refer to paper transfer section information in Chapter 8.)
9) Remove the stay plate next to the paper elevation unit. (IT screw 4x8 (2 pcs))
10) Remove the paper elevation unit. (Refer to paper transfer section information in Chapter 8.)
11) Remove the elevating unit cover. (IT screw 3x6 (1 pcs))
[ 11A-98 ]
Paper elevation unit
Stay plate
Elevating unit cover
ComColor Series (Revision 2.4)