Riso ComColor X1 series Technical Manual page 530

Type I06: Outgoing queue nearly full
Display Transmission error to the Control server. Call Service.
Do one of the following.
• Press the Close button.
• Access test mode 00414 to save data for which transmission failed on a USB memory device.
Clear
Note: To resolve the underlying problem, access test mode 00746, check settings such as settings for
communication with the admin server, and establish communication between the online remote server and
printer.
Point Description
0065 The outgoing queue for online remote functions is nearly full (at 80% capacity).
Type I08: Belt maintenance request
Display The image may not be printed in properly caused by the soiled transfer path. Call serivice.
Do one of the following.
Clear
• Press the Close button.
Note: To solve the problem, the BP belt should be cleaned of the ink or replaced with a new BP belt..
Point Description
The CIS is reading the BP belt density to be over 30%.
0229 1
Check the BP belt for ink stains.
The paper width or center of the paper detected by CIS is off position over the allowed distance.
0229 2
Check the BP belt for ink stains.
Type I09: Machine ID confl ict
Wrong-type Control Card is installed or cannot be read Control Card info.
Display The machine will be unusable if this goes on.
Replace the Control Card or contact RISO Dealer/Branch.
Clear Check the Control card.
Point Description
Wrong Control card maybe inserted. Insert correct Control card.
1936
This error message displays only during the temporary registration between the Engine control PCB and
Control card during the machine installation.
Type I10: Offset stapler maintenance
Display
Required to renew the parts in Offset stapler. Call Service.
Clear Press the Close button
Point Description
Need to replace the spare parts.
3483 1-3
1:Ceramic roller 2:Scrape roller 3:Return roller
3484
Undetermined
1: Need to replace the OST Tray Elevation Motor
3485 1-2
2: Need to replace the OST Tray Shift Motor
3486 1 Need to replace stapler harness
Type I11: PMS Battery Empty
Time setting might be incorrect or the battery might be weak.
Display
Contact the administrator. If recovery has failed, call service.
Press the Close button.
Clear
Note: To solve the problem, sets to the correct time or change the PMS battery.
Point Description
0320 The current system time (Older than Jan. 1, 2010) is not recommended to use for timer operation.
Type I15: PB GlueSheet Near Full
The perfect binder glue sheet must be replaced soon.
Display
Call service to prepare a new glue sheet.
Do one of the following.
Clear • Press the Close button.
• Add the glue sheet.
Point Description
Remaining glue sheets become under 30%.
3569
Error shows again if PB door closed within 30 seconds after open.
[ 15-99 ]
Panel Messages