Riso ComColor X1 series Technical Manual page 311

12) Remove the connector to the BP elevation motor.
Shaft for manually raising and lowering
13) Remove the BP unit elevating unit screw, pull out the shaft for manually raising and lowering from the shaft
holder, and remove the BP unit elevating unit from the head holder. (IT screw 3x6 (2 pcs))
14) Remove the BP elevation motor from the BP unit elevating unit. (IT screw 3x6 (4 pcs))
BP Unit Elevating Unit Assembly Precautions
Note: Set the BP elevating unit on the head holder unit and push it toward the back when affixing it with the
screws.
Push in this direction
[ 11A-99 ]
Ink Flow Section
BP elevation
motor
12)
Belt platen
Elevating unit
ComColor Series (Revision 2.4)