Riso ComColor X1 series Technical Manual page 871

Multifunction Finisher II (option)
4-3. Removing the S1 Gate
(1) Remove the Punch Unit.
(2) Remove Folder Gate Solenoid 1 together with the bracket. (2 screws)
> If the screws are removed from the solenoid bracket by mistake, install the solenoid at the center of the scale.
Remove these two screws
(3) Pull out the link from the rear and remove the S1 Gate.
Link
Link S1 Gate
[ 24-56 ]
Assembly positioning scale
Do not remove these screws
x1 series ComColor (Revision 0.9)