Riso ComColor X1 series Technical Manual page 803

Hide thumbs Also See for ComColor X1 series:

Table of Contents

HS5000 Scanner (option)

(9) Rotate the Guide shaft support plate back to its original condition and mount it back on the Scanner unit.

Press the Guide shaft support plate down when tightening the mounting screws (W sems screw 3x8 (2 pcs)).

(10) Hook the Timing belt on the Pulley.

(11) Hook the Timing belt on the Tension bracket. Then loosen the two screws on the Tension bracket to allow the

spring to apply appropriate tension on the belt, automatically. Jog the Scanner module to the Left and Right

several times to make sure that the spring is giving the correct tension on the Timing belt. Finally tighten the

mounting screws (IT screw 3x6 (2 pcs)).

Tension bracket

x1 series ComColor (Revision 0.9)

Chapters

Table of Contents