Disassembly; Paper Elevation Motor; Paper Elevation Unit - Riso ComColor X1 series Technical Manual

2. Disassembly

2-1. Paper Elevation Motor

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the rear cover center assembly. (Refer to Chapter 2.)
3. Put the controller PCB box in maintenance position. (Pan-head screw 4x8 (2 pcs))
4. Remove the paper elevation motor. (IT3C screw 4x8 (4 pcs))
5. Remove the paper elevation motor mounting bracket assembly. (Round tip IT3C screw 4x6 (4 pcs))
Note: After replacement, check operation by test mode 1257 (paper elevation motor).

2-2. Paper Elevation Unit

Removing the Unit
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Confirm that the BP unit and maintenance unit are in the retracted position.
3. Remove the right side cover. (Refer to Chapter 2.)
4. Remove the right top cover. (Refer to Chapter 2.)
5. Put the controller PCB box in maintenance position. (Pan-head screw 4x8 (2 pcs))
6. Remove the connector.
7. Remove the paper elevation motor assembly. (Connector (2 pcs) and IT3C screw 4x8 (4 pcs))
8. Remove the stay plate. (Pan-head screw 4x8 (2 pcs))
9. Remove the paper elevation unit. (Round tip IT3C screw 4x8 (4 pcs))
Note: Be careful of the Waste ink tube.
Stay plate
Paper elevation motor
Waste ink tube
[ 8-5 ]
Paper Transfer Section
<< Paper elevation unit >>
ComColor Series (Revision 2.4)