Riso ComColor X1 series Technical Manual page 569

Test Modes
Initialization (I)
1502 Test Mode Clear (Engine)
Restores default values for test modes that can be set by service technicians and are stored on the engine control PCB.
Values stored on multi-fi nishers are not cleared.
See information under 01502 Executed in the Initialization column under Clearing Setting Values, in "Data Editing Test Mode
Setting Values" at the end of the test mode.
1530 Error Clear (Engine)
Forces errors occurring in the engine to be cleared.
1532 Recovery Information Clear
Clears the recovery movement control data. Power OFF and ON after applying this test mode.
1533 Bellows Arm Fix Position Error Clear
This Test Mode clears the S35-2057 (Bellows Arm Fix Position Error) display.
Check for any ink overfl ow when S35-2057 error displays.
Going further without checking and correcting the overfl ow, if existing, will indicate ink overfl ow error message and may also
cause the ink colors to mix on next machine power ON.
Machine power, after executing this test mode, must be turned OFF and then ON to clear this error message. Test Mode
[No.507 Error Clear (ALL)] will not clear S35-2057 error message.
1534 Ink Detection Error Clear
Temporary clears the following S35 Ink Supply Unit Error display.
S35-2079-1 to S35-2079-4, S36-2080-1 to S36-2080-4,
S35-2081-1 to S35-2081- 2, S35-2082-1 to S35-2082-2,
S35-2083-1 to S35-2083-2, S35-2084-1 to S35-2084-2.
In need to display the error message again after activating this Test Mode to clear the error message, simply switch OFF and
then switch the machine power back ON.
This test mode only clears the above error messages temporary and may allow continued machine operation, such as initial
ink fi lling, etc. and the errors listed above may be solved by the action taken by the machine after the execution of this test
mode.
If above listed error message repeats continuously even after execution of this test mode, troubleshooting on the machine is
required.
1540 Belt Stretch Compensation Data Initialize
Initializes the belt stretch compensation data A, B and C to 0.
Rev.1.00
Upper: No./Process Name, Lower: Description
[ 16-26 ]
ComColor Unit (Series 1000)