Adjusting The Print Position [Print Position Adjustment] [1=2 Alignment] - Riso MZ970 User Manual

Adjusting the Print Position
[Print Position Adjustment] [1=2 Alignment]
The print position on the paper can be adjusted for each drum.
Adjustment range Vertical direction: ±15mm Horizontal direction: ±10mm
The positioning may be adjusted while Printing is in progress.
Note:
• After adjusting the print position, print a proof copy to check the result.
p.118
• The numerical value formed by "Print Position Adjustment" is the target. Set the actual position by verifying and
adjusting the printed material.
• Just after adjusting the print position of only one drum, traces of the previous print position remain, which may
cause blurred printing. If this occurs, make several proofs until the remaining image disappears.
p.118
• When adjusting the print position of both drums to the same location, you can do so by simply adjusting one drum.
The other will be adjusted to the same print position.
p.116
• Print position adjustment values for each drum are retained after printing is completed, to be applied for subse-
quent master making processes. The values will retained until the
Press the ,
move up or down.
1 2
1)
Adjusting the print location for Drum 1
2)
Adjusting the print location for Drum 2
3)
Key
Each press shifts the print position downward in steps of
about 0.5 mm.
Bottom Top
, or key to
3 4
5
6
7
8

Adjusting the Print Position [Print Position Adjustment] [1=2 Alignment]

key is pressed or power is turned off.
4)
Key
Press the key to move the print image about 0.5 mm to
the left on the paper.
Left Side
Right Side
5)
Original Position Indicator
Indicates when positioning has not changed.
6)
Key
Each press shifts the print position upward in steps of
about 0.5 mm.
Bottom Top
7)
Key
Press to return to original position.
8)
Key
Press the key to move the print image about 0.5 mm to
the right on the paper.
Left Side
Right Side
Functions for Printing
115