Removing The Print Drum (Cylinder) - Riso CV1200W User Manual

72
Chapter 9 Troubleshooting

Removing the print drum (cylinder)

When you want to remove jammed paper inside this
machine, you can remove the print drum (cylinder).
Caution
• Ink may be left on the area around the print drum
(cylinder) or the inside of this machine after the
print drum (cylinder) unit has been removed.
Take care not to smudge your hands or clothes
with the ink. Wash immediately with soap if you
get ink on your hands, etc.
• When you put your hands inside the main unit,
take care not to touch any protrusions or edges
of the metal plate. It may result in injury.
• Do not stand the print drum (cylinder) vertically.
Doing so may stain the floor, etc.
BUse a dedicated print drum (cylinder)
for this machine. Only black ink is
acceptable.
BKeep the power on while removing or
replacing the print drum (cylinder).
BStore the replaced print drum (cylinder)
horizontally in the print drum (cylinder)
case.
1
Press the [CYLINDER RELEASE]
key.
Make sure that the print drum (cylinder) release
lamp is turned on.
BIf you forcibly pull out the print
drum (cylinder) when its release
lamp is tuned off, the print drum
(cylinder) may be damaged.
2
Pull out the print drum (cylinder).
Grasp the print drum (cylinder) handle and pull
out the print drum (cylinder) until it stops.
3
Remove the print drum (cylinder).
Lift the print drum (cylinder) with both hands to
remove it from the guide.
BDo not touch the connector on
the print drum (cylinder).
Doing so may result in malfunc-
tion of the print drum (cylinder)
because of static electricity or
other factors.