Replacing The Print Drum; Removing The Print Drum; Open The Front Cover - Riso MZ970 User Manual

Replacing Consumables

Replacing the Print Drum

When replacing with a Colour Drum to change colours, or when removing jammed paper, follow the steps to remove
Print Drum. Be sure to use a Colour Drum specifically designed and approved for use with this machine.
B
Caution:
• Do not stand the Print Drum upright. Doing so may stain the floor, etc.
Important!:
• Use only Print Drums specifically designed and approved for use with this machine.
• Keep the power ON while removing or replacing the Print Drum.
• Make sure to place the changed Print Drum into the drum case and store horizontally.

Removing the Print Drum

Note:
• The drum is removed from the printer to be changed, and to remove paper jams.
The procedure for changing Drum 1 and Drum 2 is the same. The procedure for changing Drum 1 is explained here.
1

Open the Front Cover.

2
Check that the indicator of the Print
Drum Release Button is ON.
Print Drum
Release
Button
If the indicator is off, press the Print Drum Release
Button to turn it on.
250 Replacing the Print Drum
Important!:
• When the Master Making Unit is out, the Print
Drum cannot be pulled out. Return the Master
Making Unit into position and press the Print
Drum Release button.
p.243
Note:
• Only one of the drums may be slightly forward,
but both drums can be removed.
3
Pull out the Print Drum.
Drum Handle
Grasp the Print Drum Handle and slowly pull until
the Print Drum is completely extended.