Configuring Queue Group On Ethernet Access Ingress Port - Alcatel-Lucent 7950 Quality Of Service Manual

Queue Group Behavior on LAG

Configuring Queue Group on Ethernet Access Ingress Port

The provisioning steps involved in using a queue-group queue on an ingress port are:
•
•
•
•
The following displays an Ethernet access ingress port queue-group configuration example:
*A:Dut-T>config>port# /configure port 9/2/1
*A:Dut-T>config>port# info
----------------------------------------------
----------------------------------------------
*A:Dut-T>config>port#
Page 350
Queue Group Template Creation
→ Create the queue group template in the ingress context
→ Create the queue within the queue group template
Queue Group Creation
→ Identify the ingress port (or ports) for which the queue group will be needed (for LAG
use the primary port member)
→ Create a queue group with the same name as the template on the port or ports
Map a Forwarding Class to the queue-id within the queue group
→ Map forwarding classes to queue-group queues.
→ Identify or create the SAP ingress QoS policy that will be used on the ingress SAP
where queue redirection is desired
→ Map the desired forwarding classes to the queue group name and the specific queue
ID within the group
Apply the SAP ingress QoS policy
→ Identify or create the ingress SAP requiring forwarding class redirection to the queue
group
→ Assign the QoS policy to the SAP
ethernet
mode access
access
ingress
queue-group "QG_ingress_1" create
exit
exit
egress
queue-group "QG_egress_1" create
exit
exit
exit
exit
no shutdown
7950 XRS Quality of Service Guide