Router Ospf - Dell Z9500 Command Reference Manual

n]:
Dell#

router ospf

To configure an OSPF instance, enter ROUTER OSPF mode.
Z9500
Syntax
router ospf process-id [vrf {vrf name}]
To clear an OSPF instance, use the no router ospf process-id command.
Parameters
process-id
vrf name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.9.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage You must have an IP address assigned to an interface to enter ROUTER OSPF mode
Information and configure OSPF.
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter a number for the OSPF instance. The range is from 1 to
65535.
(Optional) E-Series Only: Enter the VRF process identifier to
tie the OSPF instance to the VRF. All network commands
under this OSPF instance are then tied to the VRF instance.
Description
Introduced on the Z9500.
Added support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRF.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1295