show interfaces flow control
Displays interface flow control wait time settings.
show interfaces [slot | slot/port[-port2]] flow [control]
Syntax Definitions
slot
slot/port[-port2]
control
Defaults
By default, flow control wait time settings are displayed for all ports on all modules.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Enter a slot number to display information for all interfaces on that slot.
•
Enter a slot and port number or a range of port numbers to display information for a specific interface
or a range of interfaces.
Examples
-> show interfaces 3/20-24 flow
Slot/Port
Active
-----------+--------+----------------+--------+-----------
3/20
-
3/21
-
3/22
-
3/23
-
3/24
-
output definitions
Slot/Port
Active
Wait time
Cfg-Flow
Cfg-Cross
page 1-74
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Optional command syntax. It displays the same information as show
interfaces flow.
Wait time(usec)
Cfg-Flow
0
0
0
0
0
Interface slot and port number
Interface status.
Flow control wait time, in microseconds.
Flow control status (Pause or Go).
The user-configured cross-over setting (Auto, MDI, or MDIX).
Cfg-Cross
Pause
MDIX
Pause
MDIX
Pause
MDIX
Go
MDIX
Go
MDIX
OmniSwitch CLI Reference Guide
Ethernet Port Commands
June 2012