Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1249

Hide thumbs Also See for OmniSwitch 6250:
Table of Contents

Advertisement

IPv6 Commands
output definitions (continued)
Packets Sent
Metric
IPv6 interface index
Interface status
Next update
Horizon mode
MTU size
Send status
Receive status
Packets received
Packets sent
Release History
Release 6.6.1; command was introduced.
Related Commands
ipv6 rip interface
ipv6 rip status
ipv6 rip interface recv-status
ipv6 rip interface send-status
ipv6 rip interface metric
ipv6 rip interface horizon
show ipv6 rip
OmniSwitch 6250 CLI Reference Guide
Number of packets sent by the interface.
RIPng metric (cost) configured for the interface.
IPv6 interface index number.
Interface status (Active/Inactive).
Seconds remaining until the next update on this interface.
Interface Horizon Mode (routing loop prevention mechanisms). Dis-
played modes are none/split-only/poison-reverse.
Maximum transmission size for RIPng packets on the interface.
Interface "Send" status. When this status is set to "enable", packets can
be sent from this interface. When it is set to "disable", packets will not
be sent from this interface.
Interface "Receive" status. When this status is set to "enable", packets
can be received by this interface. When it is set to "disable", packets
cannot be received by this interface.
Number of packets received by the interface.
Number of packets sent by the interface.
IPv6 interface name.
Enables or disables RIPng routing on the switch.
Configures the interface "Receive" status. When this status is set to
"enable", packets can be received by this interface. When it is set to
"disable", packets cannot be received by this interface.
Configures the interface "Send" status. When this status is set to
"enable", packets can be sent from this interface. When it is set to
"disable", packets will not be sent from this interface.
Configures the RIPng metric (cost) for the interface.
Configures the interface Horizon Mode (routing loop prevention
mechanisms).
Displays RIPng status and general configuration parameters (e.g.,
force holddown timer).
November 2009
page 30-83

Advertisement

Table of Contents
loading

Table of Contents