Inspection And Repair - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DI06-14

INSPECTION AND REPAIR

INSPECTION
Temperature gauge
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Cooling System
1. Release the pressure from coolant reservoir by loosening
one notch of coolant reservoir cap, and then remove the
cap.
Notice
Scalding hot coolant and steam could be blown out
under pressure, which could cause serious injury.
Never remove the coolant reservoir cap when the
before the temperature goes down below 90 ° ° ° ° ° C.
Y220_06019
2. Add the coolant up to upper mark (arrow) on the reservoir.
3. Install the tester to the coolant reservoir and apply the
pressure of 1.4 bar.
4. Check the coolant hoses, pipes and connections for leaks
after the pointer of the tester drops. Replace or retighten
as required.
Y220_06020
Thermostat
Immerse the thermostat into the water. Heat the water and
check the valve opening temperature.
Valve opening temperature
Y220_06021
DI Engine: 85 ± 2 ° C
COOLING SYSTEM
DI ENG SM - 2004.4