Coolant Temperature Gauge Unit - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Coolant Temperature Gauge Unit

1. Immerse the senor unit into the water. Heat the water
and check the resistance.
2. If the measured resistance is out of specified value,
replace the gauge unit.
3. Measure the resistance between terminal A and gauge
unit housing, and terminal B and gauge unit housing.
Terminal A
(for coolant temp.)
Terminal B
(for glow plug)
Thermostat
1. Immerse the thermostat into the oil. Heat the oil until it
reaches the specified temperature and check if the
coolant temperature switch is turned "OFF".
Coolant temperature at
point A
Coolant temperature at
point B
Notice
Use only engine oil for this inspection. Stir the oil
during heating it. Never heat the oil over required
temperature.
COOLING SYSTEM
DI ENG SM - 2004.4
0.4 Ω / 79°C
23.8 Ω / 115°C
24.8 Ω / -20°C
3.25 Ω / 20°C
113 ± 3°C
116°C
Terminal A
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DI06-15
Y220_06022
Terminal B
Y220_06023
Y220_06024