show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the ecmp-group
monitoring enable command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-
bundles).
S4810
Syntax
show running-config ecmp-group
Defaults
Disabled.
Command Modes
CONFIGURATION
Command History
Version 8.3.10.0
Related
ecmp-group
Commands
shutdown
Disable an interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults
The interface is disabled.
Command Modes
INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
The shutdown command marks a physical interface as unavailable for traffic. To discover if
Information
an interface is disabled, use the show ip interface brief command. Disabled
interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the
Layer 3 functions within that VLAN are disabled. Layer 2 traffic continues to flow. Entering the
746
Introduced on the S4810.
– configures a mechanism to monitor traffic distribution.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.