Section 2 Repair Analysis Procedures - Xerox 8830 Service Manual

About this Manual
This manual is part of a documentation system
that includes the training.
This manual contains Repair
Procedures (RAPs), Repair
Adjustment Procedures, Parts List, Diagnostic
Procedures, Installation Procedures, Wiring Data
and BSDs.
This manual will enable
Representative to repair the 8830.
Organization
This manual consists of eight sections. The
title and description of each section are listed
below.
Section 1 Service Call Procedures
This section contains the following:
• Call Flow Diagram
• Initial Actions/ System Checks
• Printer Maintenance
• Status Code Entry Chart
• System Checkout/ Final Action
Call Flow Diagram
The Call Flow Diagram is a map of activities to
be performed on each service call.
Introduction
Initial Actions/ System Checks
This diagram identifies how to collect the data
necessary to decide how to proceed with the
service call. It classifies the problem and refers
Analysis
you to the appropriate RAP.
Procedures,
Status Code Entry Chart
This chart provides a list of status codes, the
possible cause, whether there is a RAP in
the Service
Section 2, component control code, and a BSD
reference.
Printer Maintenance
The Maintenance Activities procedures identify
functional checks and cleaning operations that
must be performed on every Normal Call. It also
identifies those activities that can be performed
as needed or as scheduled.
Subsystem Checks
The Subsystem Checks consist of checks and
activities that must be performed when a
subsystem is repaired during a Callback or when
directed to them during Normal Call.
System Checkout
The System Checkout procedure is used to
verify that the printer is operating correctly after a
repair has been made.
1/98
vi
Final Action
The Final Action procedure identifies the steps
that must be performed before closing out the
service call.
Section 2. - Repair Analysis Procedures
(RAPs)
This section contains the Repair Analysis
Procedures (RAPs) necessary to repair the
faults. When using a RAP, always exit the
procedure when the fault is fixed.
perform the remaining steps.
Section 3. - Image Quality Repair Analysis
Procedures (RAPs)
This section contains the Repair Analysis
Procedures (RAPs) necessary to repair the
image quality faults. Refer to "How to Use the
Image Defect Definitions" to compare the image
defect to the definitions. Once you have
determined the definition that best describes the
defect, go to the section contents page to find
the appropriate RAP. When using a RAP,
always exit the procedure when the fault is fixed.
Do not perform the remaining steps.
Section 4. - Repair / Adjustment
This section contains the repair and adjustment
procedures for the 8830.
Section 5. - Parts List
This section contains the detailed Parts List for
the 8830.
Do not
8830