Jam Errors; Jam At Tray - Xerox Phaser 6125 Service Manual

Jam Errors

Jam at Tray

Phaser 6125/6130 Color Laser Printer Service Manual
Paper fed from Paper Tray did not reach the Registration Sensor on time.
Initial Actions
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Cassette Assy 250 (PL2.1.1)
Separator Roller Assembly (PL2.1.5)
Drive Clutch Assembly Kit
(PL3.1.99)
Feed Solenoid Kit (PL3.1.98)
Left Side Harness Assy (PL3.1.18)
Feed Roller Assembly (PL3.2.4)
Regi Roll Actuator (PL3.2.8)
Regi In Actuator (PL3.2.11)
Photo Sensor (PL3.2.13)
Main Drive Assembly (PL7.1.2)
MCU Board (PL8.2.13)
Troubleshooting Procedure Table
Step Actions and Questions
Check the paper condition
1
Is the paper in the Tray wrinkled or
damaged?
2 Reload fresh paper in the Tray.
Does the error still occur when
printing?
3 Check the Front Cover for latching
Open and close the Front Cover, and
then latch correctly.
Does the error still occur when
printing?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-9
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Feeder, Manual Feed, & Registration" on
page 10-19
Yes No
Go to step 2. Go to step 3.
Go to step 3. Complete
Go to step 4. Complete
3-29