Dell S4810 Reference Manual page 255

Hide thumbs Also See for S4810:

Table of Contents

address-mask

Not configured

CONFIGURATION-MAC ACCESS LIST-STANDARD

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 8.1.1.0

Version 7.6.1.0

Access Control Lists (ACL)

Enter the keyword deny to configure a filter to drop packets

meeting this condition.

Enter the keyword permit to configure a filter to forward

packets meeting this criteria.

Enter the keyword any to filter all packets.

Enter a MAC address in nn:nn:nn:nn:nn:nn format.

(OPTIONAL) Specify which bits in the MAC address must

match. If no mask is specified, a mask of 00:00:00:00:00:00

is applied (in other words, the filter allows only MAC

addresses that match).

(OPTIONAL) Enter the keyword count to count packets the

filter processes.

(OPTIONAL) Enter the keyword byte to count bytes the filter

(OPTIONAL, E-Series only) Enter the keyword log to log the

(OPTIONAL) Enter the keyword monitor when the rule is

describing the traffic that you want to monitor and the ACL

in which you are creating the rule is applied to the monitored

NOTE: For more information, refer to the "Flow-based

Monitoring" section in the Port Monitoring chapter of the

Dell Networking OS Configuration Guide.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.