Set Automatic-Tag - Dell S4810 Reference Manual

To remove an AS-Path setting, use the no set as-path {prepend as-number
| tag} command.
Parameters
prepend as-
number
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
You can prepend up to eight AS numbers to a BGP route.
Information
This command influences best path selection in BGP by inserting a tag or AS
number into the AS_PATH attribute.
Related
match as-path
Commands

set automatic-tag

To automatically compute the tag value of the route, configure a filter.
S4810
Syntax
set automatic-tag
To return to the default, enter no set automatic-tag.
Access Control Lists (ACL)
Enter the keyword prepend and then enter up to eight AS
numbers to be inserted into the BGP path information. The
range is from 1 to 65535.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match an AS-PATH attribute.
283