Dell S4810 Reference Manual page 306

Hide thumbs Also See for S4810:

Table of Contents

[operator port [port]] [count [byte]] [order] [fragments] [log

[interval minutes] [threshold-in-msgs [count]]

To remove this filter, you have two choices:

threshold-in

By default, 10 ACL logs are generated if you do not specify the threshold explicitly.

The default frequency at which ACL logs are generated is five minutes.

CONFIGURATION-EXTENDED-ACCESS-LIST

Version 9.3(0.0)

When the configured maximum threshold is exceeded, generation of logs is

stopped. When the interval at which ACL logs are configured to be recorded

expires, the subsequent, fresh interval timer is started and the packet count for that

new interval commences from zero. If ACL logging was stopped previously

because the configured threshold is exceeded, it is re-enabled for this new interval.

If ACL logging is stopped because the configured threshold is exceeded, it is re-

enabled after the logging interval period elapses. ACL logging is supported for

standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure

ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable

logging for ACLs that are associated with egress interfaces.

Use the no seq sequence-number command if you know the filter's

sequence number.

Use the no deny udp {source mask | any | host ip-address}

{destination mask | any | host ip-address} command.

(OPTIONAL) Enter the keyword log to enable the triggering

of ACL log messages.

(OPTIONAL) Enter the threshold-in-msgs keyword

followed by a value to indicate the maximum number of ACL

logs that can be generated, exceeding which the generation

of ACL logs is terminated. with the seq, permit, or deny

commands. The threshold range is from 1 to 100.

(OPTIONAL) Enter the keyword interval followed by the

time period in minutes at which ACL logs must be generated.

The time interval range is from 1 to 10 minutes.

Added support for logging of ACLs on the S4810, S4820T,

and Z9000 platforms.

— assigns a filter to deny IP traffic.

— assigns a filter to deny TCP traffic.

Access Control Lists (ACL)