Set Tag - Dell S4810 Reference Manual

pre-Version
6.1.1.0

set tag

To specify a tag for redistributed routes, configure a filter.
S4810
Syntax
set tag tag-value
To delete a setting, use the no set tag command.
Parameters
tag-value
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set metric-type
Access Control Lists (ACL)
Introduced on the E-Series.
Enter a number as the tag. The range is from zero (0) to
4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the route type assigned to redistributed routes.
293