Match Interface - Dell S4810 Reference Manual

match interface

To match routes whose next hop is on the interface specified, configure a filter.
S4810
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Access Control Lists (ACL)
Enter the following keywords and slot/port or number
information:
• .
• For the loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094 (you can use IDs 1 to 4094).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
273