Set Level - Dell S4810 Reference Manual

pre-Version
6.1.1.0
Related
match community
Commands
show ip bgp community

set level

To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
S4810
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1
| level-1-2 | level-2 | stub-area} command.
Parameters
backbone
level-1
level-1-2
level-2
stub-area
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Dell Networking OS Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Access Control Lists (ACL)
Introduced on the E-Series.
— redistributes routes that match the COMMUNITY attribute.
— displays BGP community groups.
Enter the keyword backbone to redistribute matched routes
to the OSPF backbone area (area 0.0.0.0).
Enter the keyword level-1 to redistribute matched routes
to IS-IS Level 1.
Enter the keyword level-1-2 to redistribute matched
routes to IS-IS Level 1 and Level 2.
Enter the keyword level-2 to redistribute matched routes
to IS-IS Level 2.
Enter the keyword stub to redistributed matched routes to
OSPF stub areas.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
287