Description - Dell S4810 Reference Manual

With a match clause and a continue clause, the match clause executes first and the
continue clause next in a specified route map entry. The continue clause launches
only after a successful match. The behavior is:
•
•
•
Set Clause with Continue Clause
If the route-map entry contains sets with the continue clause, set actions are
performed first then the continue clause jumps to the specified route map entry.
•
•
Related
set community
Commands
set as-path

description

Add a description to this route map.
S4810
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description
Defaults none
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
270
A successful match with a continue clause, the route map executes the set
clauses and then goes to the specified route map entry upon execution of the
continue clause.
If the next route map entry contains a continue clause, the route map executes
the continue clause if a successful match occurs.
If the next route map entry does not contain a continue clause, the route map
evaluates normally. If a match does not occur, the route map does not
continue and falls through to the next sequence number, if one exists.
If a set action occurs in the first route map entry and then the same set action
occurs with a different value in a subsequent route map entry, the last set of
actions overrides the previous set of actions with the same set command.
If set community additive and set as-path prepend are configure, the
communities and AS numbers are prepended.
— specifies a COMMUNITY attribute.
— configures a filter to modify the AS path.
Enter a description to identify the route map (80 characters
maximum).
Access Control Lists (ACL)