Dell S4810 Reference Manual page 261

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

ethertype
operator
count
byte
log
monitor
Defaults
Not configured.
Command
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.1.1.0
Access Control Lists (ACL)
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
ev2 - is the Ethernet II frame format
llc - is the IEEE 802.3 frame format
snap - is the IEEE 802.3 SNAP frame format
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
Introduced on the E-Series.
261

Advertisement

Table of Contents
loading

Table of Contents