Match Origin - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
routers.
match route-type
match tag

match origin

To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.
S4810
Syntax
match origin {egp | igp | incomplete}
To disable matching filter, use the no match origin {igp | egp |
incomplete} command.
Parameters
egp
igp
incomplete
Defaults Not configured.
278
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keyword egp to match routes originating outside
the AS.
Enter the keyword igp to match routes originating within
the same AS.
Enter the keyword incomplete to match routes with
incomplete routing information.
Access Control Lists (ACL)