Show Ip Ospf Host - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

OSPF Commands

show ip ospf host

Displays information on the configured OSPF hosts.
show ip ospf host [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command is used to display general information for OSPF hosts directly attached to this router.
•
See the Related Commands section below to modify the list.
Examples
-> show ip ospf host 172.22.2.115
Host Address
-----------------+-------+-----------+--------+-----------------
143.209.92.12
output definitions
Host Address
ToS
Metric
Status
AreaId
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
A 32-bit IP address for a directly attached host.
TOS Metric Status
1 0
A 32-bit IP address for a directly attached host. This can be set using
the ip ospf host
The Type of Service traffic from the host is labeled as. ToS is set using
the ip ospf host
The metric assigned to the host. Metric is set using the
command.
Whether the host is enabled or disabled.
The area identification for the host's area.
March 2011
AreaId
Up 0.0.0.0
command.
command.
show ip ospf host
ip ospf host
page 17-59