Ip Ospf Extlsdb-Limit - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

OSPF Commands

ip ospf extlsdb-limit

Assigns a limit to the number of External Link-State Database (LSDB) entries that can be learned.
ip ospf extlsdb-limit limit
Syntax Definitions
limit
Defaults
parameter
limit
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command allows you to set a limit to the number of external LSDBs learned by the router. An
external LSDB is created when the router learns a link address that exists outside of its Autonomous
System (AS).
•
When the limit is set, and it is exceeded, older addresses that were previously learned are removed
from the routing table to make room for the new external LSDB.
Example
-> ip ospf extlsdb-limit 25
Release History
Release 7.1.1; command was introduced.
Related Commands
show ip ospf
MIB Objects
ospfGeneralGroup
ospfExtLsdbLimit
OmniSwitch CLI Reference Guide
The maximum number of LSDB entries allowed on the router. The
accepted value is any number greater than or equal to 1. If 0 is entered,
there is no limit.
default
-1
Displays OSPF status and general configuration parameters.
March 2011
ip ospf extlsdb-limit
page 17-7