Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 829

VRRP Commands
output definitions
VRRP trap generation
VRRP startup delay
VRID
VLAN
IPv6 Address(es)
Admin Status
Priority
Preempt
Accept
Virtual MAC
Adv. Interval
Release History
Release 7.1.1; command was introduced.
Related Commands
vrrp3
vrrp3 address
show vrrp3 statistics
OmniSwitch CLI Reference Guide
Whether or not VRRP trap generation is enabled or disabled.
The amount of time after a reboot that virtual routers will wait before
they go active; allows time for routing tables to stabilize.
Virtual router identifier. Configured through the
The VLAN associated with the VRRP3 instance. Configured through
the vrrp3 command.
The assigned IPv6 addresses. Configured through the
command.
The administrative status of this virtual router instance; enabled allows
the virtual router instance to operate; disabled disables the virtual
router instance without deleting it.
Indicates the VRRP3 router's priority for the virtual router. For more
information about priority, see the
16-30.
Controls whether a higher priority virtual router will preempt a lower
priority master: preempt indicates that a higher priority virtual router
will preempt a lower priority master; no preempt indicates that the first
backup router to take over for the master will not be preempted by a
virtual router with a higher priority. In either case the IP address owner
will always take over it if is available.
Displays whether the master router, which is not the IPv6 address
owner will accept the packets addressed to the IPv6 address owner as
its own.
Displays the virtual MAC address for the virtual router when the router
is in the master state. The first 5 bytes are always 00-00-5E-00-02. The
last byte indicates the VRID. This field displays N/A when the virtual
router is in the backup or initialize state.
Indicates the time interval, in seconds, between sending advertisement
messages. Only the master router sends advertisements.
Configures a new VRRP3 virtual router or modifies an existing one.
Used to enable or disable a virtual router.
Configures an IPv6 address for a virtual router.
Displays statistics for all virtual routers configured on the switch or for a
specific virtual router.
March 2011
vrrp3 command.
vrrp3 address
vrrp3 command description on
show vrrp3
page
page 16-51