Ip Ospf Default-Originate - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

OSPF Commands

ip ospf default-originate

Configures a default external route into the OSPF routing domain.
ip ospf default-originate {only | always} [metric-type {type1 | type2}] [metric value]
no ip ospf default-originate
Syntax Definitions
only
always
type1
type2
value
Defaults
parameter
type1 | type2
value
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of the command to delete redistributed default routes.
Examples
-> ip ospf default-originate always
-> ip ospf default-originate only metric 10
-> ip ospf default-originate always metric-type type1 metric 5
-> no ip ospf default-originate
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
Advertises only when there is a default route in the routing table.
Advertises the default route regardless of whether the routing table has a
default route.
Sets the external route as type1.
Sets the external route as type2.
The metric value.The valid range is 1-65535.
default
type2
1
March 2011
ip ospf default-originate
page 17-11