Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 815

VRRP Commands
-> show vrrp 1
Virtual Router VRID = 1 on VLAN = 1
Admin Status
Priority
Preempt
Adv. Interval
Virtual MAC
IP Address(es)
192.168.170.1
192.168.170.2
output definitions
VRRP default advertisement
interval
VRRP default priority
VRRP default preempt
VRRP trap generation
VRRP startup delay
VRID
VLAN
IP Address(es)
Admin Status
Priority
Preempt
Virtual MAC
Adv. Interval
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
= Enabled
= 255
= Yes
= 1
= 00-00-5E-00-02-01
The default advertising interval for all virtual routers on the switch.
The default priority value for all virtual routers on the switch.
The default preempt mode for all virtual routers on the switch.
Indicates whether or not the VRRP trap generation is enabled or
disabled; configured through the
The amount of time after a reboot that virtual routers will wait before
they go active; allows time for routing tables to stabilize. Configured
through the vrrp delay
Virtual router identifier. Configured through the
The VLAN associated with the VRRP instance. Configured through the
vrrp command.
The assigned IP addresses. Configured through the
mand.
The administrative status of this virtual router instance; enabled allows
the virtual router instance to operate; disabled disables the virtual
router instance without deleting it.
Indicates the VRRP router's priority for the virtual router. For more
information about priority, see the
page 16-3.
Controls whether a higher priority virtual router will preempt a lower
priority master router: preempt indicates that a higher priority virtual
router will preempt a lower priority master; no preempt indicates that
the first backup router to take over for the master will not be preempted
by a virtual router with a higher priority. In either case, the IP address
owner will always take over it if is available.
Displays the virtual MAC address for the virtual router. The first 5
bytes are always 00-00-5E-00-02. The last byte indicates the VRID.
This field displays N/A when the virtual router is in the backup or ini-
tialize state.
Indicates the time interval, in seconds, between sending advertisement
messages. Only the master router sends advertisements.
March 2011
vrrp track command.
command.
vrrp
vrrp command description on
show vrrp
command.
vrrp address com-
page 16-37