Ip Ospf Interface Type - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

OSPF Commands

ip ospf interface type

Configures the OSPF interface type.
ip ospf interface {interface_name} type {point-to-point | point-to-multipoint | broadcast | non-broad-
cast}
Syntax Definitions
interface_name
point-to-point
point-to-multipoint
broadcast
non-broadcast
Defaults
parameter
broadcast | non-broadcast |
point-to-point|
point-to-multipoint
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command sets an interface to be broadcast, non-broadcast, point-to-point, or point-to-multipoint.
•
If the type is non-broadcast or point-to-multipoint, static neighbors should be configured.
Examples
-> ip ospf interface vlan-101 type non-broadcast
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the interface.
Sets the interface to be a point-to-point OSPF interface.
Sets the interface to be a point-to-multipoint OSPF interface.
Sets the interface to be a broadcast OSPF interface.
Sets the interface to be NBMA (Non Broadcast Multi Access) OSPF
interface.
default
broadcast
March 2011
ip ospf interface type
page 17-39