Show Vrrp Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show vrrp group

show vrrp group
Displays the default parameter values for all the virtual router groups or for a specific virtual router group.
show vrrp group [vrgid]
Syntax Definitions
vrgid
Defaults
By default, the default parameter values are displayed for all the virtual router groups.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the vrgid parameter with this command to display the default values for a specific virtual router group.
Examples
-> show vrrp group 2
Virtual Router Group GROUPID = 2
Interval = 11
Priority = 250
Preempt Mode = Yes
3 Associated Virtual Routers
output definitions
Group ID
Adv Interval
Priority
Preempt Mode
Release History
Release 7.1.1; command was introduced.
page 16-46
The virtual router group ID, in the range from 1–255.
The virtual router group identifier.
Indicates the time interval, in seconds, between the sending of
advertisement messages. Only the master router sends advertisements.
Indicates the VRRP router's priority for the virtual router group. For
more information about priority, see the
page 16-3.
Controls whether a higher priority virtual router will preempt a lower
priority master; preempt indicates that a higher priority virtual router
will preempt a lower priority master; no preempt indicates that the first
backup router to take over for the master will not be preempted by a
virtual router with a higher priority. In either case, the IP address owner
will always take over it if is available.
vrrp command description on
OmniSwitch CLI Reference Guide
VRRP Commands
March 2011