Show Ip Ospf Area Range - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ip ospf area range

show ip ospf area range
Displays all or specified route summaries in a given area.
show ip ospf area area_id range [{summary | nssa} ip_address ip_mask]
Syntax Definitions
area_id
summary
nssa
ip_address
ip_mask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Allows you to view the details of a specified OSPF area range.
•
See the Related Commands section below for information on modifying an area.
Examples
-> show ip ospf area 0.0.0.0 range
AreaId
---------------+---------+------------------+-----------
0.0.0.0
0.0.0.0
output definitions
AreaId
Type
Destination
Advertise
Release History
Release 7.1.1; command was introduced.
page 17-76
A unique 32-bit value in IP address format.
Specifies that routes are summarized.
Specifies the Not So Stubby Area (NSSA) routers are summarized.
A 32-bit IP address.
A 32-bit subnet mask.
Type Destination
Summary 192.168.12.1/24
NSSA 143.209.92.71/24
The area identification for the area range.
The type of area the range is associated with.
The destination address of the range.
Shows the filter effect of the range. LSAs in the range are either adver-
tised (Matching) or not advertised (noMatching).
Advertise
Matching
noMatching
OmniSwitch CLI Reference Guide
OSPF Commands
March 2011