Show Ip Ospf Lsdb - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

OSPF Commands

show ip ospf lsdb

Displays LSAs in the Link State Database associated with each area.
show ip ospf lsdb [area_id] [rtr | net | netsum | asbrsum] [linkstate-id ls_id] [router-id router_id]
Syntax Definitions
area_id
rtr
net
netsum
asbrsum
ls_id
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command is used to display the Link State Database (LSDB) of the OSPF router. This command
can be used for OSPF debugging purposes, specifically to narrow down sections of an area to deter-
mine which sections are receiving the specified link state advertisements. You may specify only the
parameters from the area LSDB in which you are interested using the optional command parameters.
•
You can view link state advertisements by specifying either a link state identifier or a router identifier.
However, when specifying a router ID, you must also supply a valid link state ID.
Examples
-> show ip ospf lsdb
Area Id
----------------+-------+----------------+----------------+------------+-----
0.0.0.1
output definitions
Area Id
Type
LS Id
OmniSwitch CLI Reference Guide
A unique 32-bit value in IP address format.
Specifies router LSAs.
Specifies network LSAs.
Specifies network summary LSAs.
Specifies Autonomous System Border Router summary LSAs.
The Link state ID. The ID is a unique 32-bit value, such as an IP
address. This number is used as a record in the link state database.
The Router ID. The ID is a unique 32-bit value such as an IP address.
Type LS Id
OSPF 198.168.100.100
The area identification for the area to which the record belongs.
The protocol type from where the route was learned.
The Link state ID. The ID is a unique 32-bit value such as an IP
address. This number is used as a record in the link state database.
March 2011
Orig Router-Id
198.168.100.100
show ip ospf lsdb
SeqNo Age
1 100
page 17-61