Ip Ospf Host - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip ospf host

ip ospf host
Creates and deletes an OSPF entry for directly attached hosts. Allows for the modification of the host
parameters of Type of Service (ToS) and metric.
ip ospf host ip_address tos tos [metric metric]
no ip ospf host ip_address tos tos
Syntax Definitions
ip_address
tos
metric
Defaults
parameter
metric
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The no variant of this command removes the record of the OSPF host.
•
Use this command when multiple paths exist to a host. The specified host must be directly attached to
the router. ToS routing is the ability to make a forwarding decision based on a destination address and a
desired Quality of Service (QoS). ToS routing allows link selection based on QoS when more than one
path exists between a source and a destination.A metric value is the cost of all the hops necessary for a
packet to reach its destination. Routers use the metric to determine the best possible path
Examples
-> ip ospf host 172.22.2.115 tos 1 metric 10
-> no ip ospf host 172.22.2.115 tos 1
Release History
Release 7.1.1; command was introduced.
page 17-8
The 32-bit IP address in dotted decimal format of the OSPF host. See
the example below for more information.
The type of service (ToS) of the specified OSPF host. The valid range is
0- 15. Only ToS value 0 is supported at this time.
The cost metric value assigned to the specified host. The valid range is 0
and up.
default
0
OmniSwitch CLI Reference Guide
OSPF Commands
March 2011