Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 908

show ip ospf area
output definitions
Area Identifier
Admin Status
Operational Status
Area Type
Area Summary
Time since last SPF Run
# of Area Border Routers
known
# of AS Border Routers known The number of Autonomous System Border Routers in the area.
# of LSAs
# of SPF Calculations
# of Incremental SPF Calcula-
tions
# of Neighbors in Init State
# of Neighbors in 2-Way State The number of OSPF 2-way state neighbors in this area.
# of Neighbors in Exchange
State
# of Neighbors in Full State
# of Interfaces attached
Attached Interfaces
Release History
Release 7.1.1; command was introduced.
Related Commands
ip ospf area
ip ospf area range
show ip ospf interface
page 17-74
The unique 32-bit value, such as IP address, that identifies the OSPF
area in the AS.
Whether the area is enabled or disabled.
Whether the area is active.
The area type. This field will be normal, stub, or NSSA.
Whether Area Summary is enabled or disabled.
The last time the Shortest Path First calculation was performed.
The number of Area Border Routers in the area.
The total number of Link State Advertisements for the Area.
The number of times the area has calculated the Shortest Path.
The number of incremental Shortest Path First calculations that have
been performed in the area.
The number of OSPF neighbors that are in initialization.
The number of OSPF neighbors that are currently establishing their sta-
tus.
The number of OSPF neighbors.
The number of OSPF interfaces.
The names of the OSPF interfaces attached to this area.
Creates or deletes an OSPF area, assigning default metric, cost, and
type.
Creates a route summarization instance whereby a range of
addresses will be advertised as a single route.
Displays OSPF interface information.
OmniSwitch CLI Reference Guide
OSPF Commands
March 2011