Ip Ospf Exit-Overflow-Interval - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip ospf exit-overflow-interval

ip ospf exit-overflow-interval
This command sets the overflow interval value.
ip ospf exit-overflow-interval seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The overflow interval is the time whereby the routing router will wait before attempting to leave the
database overflow state; the interval begins upon the routing router's arrival into this state.
•
When the routing router leaves the overflow state, it can once again create non-default and external link
state advertisements (LSAs) for autonomous systems (AS).
•
Note that the router will not leave the overflow state (until it is restarted) when the overflow interval
value is set to 0.
Example
-> ip ospf exit-overflow-interval 10
Release History
Release 7.1.1; command was introduced.
Related Commands
show ip ospf
MIB Objects
ospfGeneralGroup
ospfExitOverflowInterval
page 17-6
The number of seconds the router waits before attempting to leave the
overflow state.
default
0
Displays the OSPF status and general configuration parameters.
OmniSwitch CLI Reference Guide
OSPF Commands
March 2011