OSPFv3 Commands
ipv6 ospf host
Creates or deletes an OSPFv3 entry for directly attached hosts.
ipv6 ospf host ipv6_address [area area_id] [metric metric]
no ipv6 ospf host ipv6_address area area_id
Syntax Definitions
ipv6_address
area_id
metric
Defaults
parameter
metric
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove the record of the OSPFv3 host.
•
Use this command when multiple paths exist to a host. The specified host must be directly attached to
the router. A metric value is the cost of all the hops necessary for a packet to reach its destination.
Routers use the metric to determine the best possible path.
•
This command allows you to modify the host parameter metric.
Examples
-> ipv6 ospf host 2001::1/64 metric 10
-> no ipv6 ospf host 2001::1/64 metric 10
Release History
Release 7.1.1; command was introduced.
Related Commands
show ipv6 ospf host
OmniSwitch CLI Reference Guide
The 128-bit IP address of the OSPF host.
Area to which the host route belongs.
The cost metric value assigned to the specified host. The valid range is
0–65535.
default
0
Displays information on the configured OSPFv3 hosts.
March 2011
ipv6 ospf host
page 18-5