ipv6 ospf interface hello-interval
ipv6 ospf interface hello-interval
Configures the OSPFv3 interface hello interval.
ipv6 ospf interface interface_name hello-interval seconds
Syntax Definitions
interface_name
seconds
Defaults
parameter
seconds
(broadcast and point-to-point)
seconds
(NBMA and point-to-multi-
point)
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This is the interval between two consecutive hello packets sent out on this interface.
Examples
-> ipv6 ospf interface vlan-101 hello-interval 50
Release History
Release 7.1.1; command was introduced.
Related Commands
ipv6 ospf interface dead-
interval
show ipv6 ospf interface
MIB Objects
ospfv3IfTable
ospfv3IfIndex
ospfv3IfHelloInterval
page 18-20
The name of the interface.
The hello interval, in seconds. The valid range is 1–65535.
default
10
30
Configures the OSPFv3 interface dead interval.
Displays the status and statistics of an OSPFv3 interface.
OmniSwitch CLI Reference Guide
OSPFv3 Commands
March 2011