Configure Pim Add Vlan - Extreme Networks ExtremeWare Command Reference Manual

IP Multicast Commands

configure pim add vlan

For the "i" series of switches:
configure pim add vlan [<vlan name> | all] {dense | sparse}
For the "e" series of switches:
configure pim add {vlan} [<vlan name>] {passive}
Description
Enables PIM on one or more IP interfaces.
Syntax Description
vlan name
all
dense
passive
sparse
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
On the "i" Series of Switches. The switch supports both dense mode and sparse mode operation.
You can configure dense mode or sparse mode on a per-interface basis. After they are enabled, some
interfaces can run dense mode, while others run sparse mode.
On the "e" Series of Switches. The switch supports edge mode operation. You can configure
spare-mode on a per-interface basis.If you specify passive, the interface does not act as a neighbor with
another PIM router or switch. Typically all non-passive interfaces align with USPF non-passive
interfaces. A maximum of 2 non-passive PIM interfaces is allowed on the "e" series.
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
configure pim add vlan accounting dense
1962
Specifies a VLAN name.
Specifies all VLANs.
NOTE: This option is only available on the "i" series of switches.
Specifies PIM dense mode (PIM-DM).
NOTE: This option is only available on the "i" series of switches.
Specifies the IP interface as passive.
NOTE: This option is only available on the "e" series of switches.
Specifies PIM sparse mode (PIM-SM).
NOTE: This option is only available on the "i" series of switches.
ExtremeWare 7.5 Command Reference Guide