Configure Pim Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
IP Multicast Commands

configure pim add vlan

configure pim add vlan [<vlan-name> | all] {dense | sparse} {passive}
Description
Configures an IP interface for PIM.
Syntax Description
vlan-name
all
dense
sparse
passive
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Passive interfaces are host only interfaces that allow a multicast stream from other VLANs to be
forwarded to edge hosts. Since they do not peer with other PIM routers, do not connect a multicast
router to a passive interface.
In order for the interface to participate in PIM, PIM must be enabled on the switch using the following
command:
enable pim
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
configure pim add vlan accounting dense
History
This command was first available in ExtremeWare XOS 10.1.
The
passive
1812
Specifies a VLAN name.
Specifies all VLANs.
Specifies PIM dense mode (PIM-DM).
Specifies PIM sparse mode (PIM-SM).
Specifies a passive interface.
parameter was added in ExtremeWare XOS 11.1.
ExtremeWare XOS 11.5 Command Reference Guide