Configure Pim Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

configure pim add vlan

configure pim add vlan [<vlan_name> | all] {dense | sparse} {passive}
Description
Enables PIM on an IP interface.
Syntax Description
vlan_name
all
dense
sparse
passive
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Passive interfaces do not peer with other PIM routers on the VLAN.
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
configure pim add vlan accounting dense
History
This command was first available in ExtremeWare XOS 10.1.
The parameter was added in ExtremeWare XOS 11.1.
passive
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies a VLAN name.
Specifies all VLANs.
Specifies PIM dense mode (PIM-DM).
Specifies PIM sparse mode (PIM-SM).
Specifies a passive interface
configure pim add vlan
1543