Configure Igmp Snooping Leave-Timeout - Extreme Networks ExtremeWare Command Reference Manual

IP Multicast Commands

configure igmp snooping leave-timeout

configure igmp snooping leave-timeout <leave_time ms>
Description
Configures the IGMP snooping leave timeout.
Syntax Description
leave_time ms Specifies an IGMP leave timeout value in milliseconds.
Default
1000 ms.
Usage Guidelines
The value could be 0 or in a range of 1000 to 10000 milliseconds (1 to 10 seconds). The value specified
will be rounded off to multiple of 1000 milliseconds.
The specified time is the maximum leave timeout value. The switch could leave sooner if an IGMP
leave message is received before the timeout occurs.
Example
The following command configures the IGMP snooping leave timeout:
configure igmp snooping leave-timeout 10000
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
2026 ExtremeWare 7.7 Command Reference Guide