Configure Ospf Area Add Range - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
OSPF Commands

configure ospf area add range

configure ospf area <area-identifier> add range [<ip-address> <ip-mask> |
<ipNetmask>] [advertise | noadvert] [type-3 | type-7]
Description
Configures a range of IP addresses in an OSPF area to be aggregated.
Syntax Description
area-identifier
ip-address
ip-mask
ipNetmask
advertise
noadvertise
type-3
type-7
Default
N/A.
Usage Guidelines
If advertised, the aggregated IP range is exported as a single LSA by the ABR.
Example
The following command is used to summarize a certain range of IP addresses within an area and export
them out as a single address:
configure ospf area 1.2.3.4 add range 10.1.2.0/24 advertise type-3
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1548
Specifies an OSPF area.
Specifies an IP address
Specifies a subnet mask.
Specifies IP address / Netmask.
Specifies to advertise the aggregated range of IP addresses.
Specifies not to advertise the aggregated range of IP addresses.
Specifies type 3 LSA, summary LSA.
Specifies type 7 LSA, NSSA external LSA.
ExtremeWare XOS 11.5 Command Reference Guide