Configure Ospf Area Add Range - Extreme Networks ExtremeWare Command Reference Manual

configure ospf area add range

configure ospf area <area identifier> add range <ipaddress> <mask>
[advertise | noadvertise] {type-3 | type-7}
Description
Configures a range of IP addresses in an OSPF area to be aggregated.
Syntax Description
area identifier
ipaddress
mask
advertise
noadvertise
type-3
type-7
Default
N/A.
Usage Guidelines
If advertised, the aggregated IP range is exported as a single LSA by the ABR.
Example
The following command is used to summarize a certain range of IP addresses within an area and export
them out as a single address:
configure ospf area 1.2.3.4 add range 10.1.2.0/24 advertise type-3
History
This command was available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
Specifies an OSPF area.
Specifies an IP address
Specifies a subnet mask.
Specifies to advertise the aggregated range of IP addresses.
Specifies not to advertise the aggregated range of IP addresses.
Specifies type 3 LSA, summary LSA.
Specifies type 7 LSA, NSSA external LSA.
configure ospf area add range
1735