Enable Icmp Address-Mask - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

enable icmp address-mask

enable icmp address-mask {vlan <vlan name>}

Enables the generation of an ICMP address-mask reply on one or all VLANs.

Syntax Description

Specifies a VLAN name.

Usage Guidelines

Enables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask

request is received.The default setting is enabled. If a VLAN is not specified, the command applies to all

IP interfaces.

This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually

forwarded by the switch is controlled by the access-list commands.

The following command enables the generation of an ICMP address-mask reply on VLAN accounting:

enable icmp address-mask vlan accounting

This command was first available in ExtremeWare 6.1.

Platform Availability

This command is available on "i" series platforms.

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0