Configure Vlan Add Ports Stpd - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
STP Commands

configure vlan add ports stpd

configure vlan <vlan_name> add ports [all | <port_list>] {tagged |
untagged} stpd <stpd_name> {[dot1d | emistp | pvst-plus]}
Description
Adds one or more ports in a VLAN to a specified STPD.
Syntax Description
vlan_name
all
port_list
tagged
untagged
stpd_name
dot1d
emistp
pvst-plus
Default
Ports in the default STPD (s0) are in
Ports in user-created STPDs are in
Usage Guidelines
To create a VLAN, use the
command.
In an EMISTP or PVST+ environment, this command adds a list of ports to a VLAN and a specified
STPD at the same time provided the carrier VLAN already exists on the same set of ports. You can also
specify the encapsulation mode for those ports.
In an MSTP environment, you do not need a carrier VLAN. A CIST controls the connectivity of
interconnecting MSTP regions and sends BPDUs across the regions to communicate region status. You
must use the dot1d encapsulation mode in an MSTP environment.
You cannot configure STP on the following ports:
Mirroring target ports
●
Software-controlled redundant ports
●
Netlogin ports
●
1204
Specifies a VLAN name.
Specifies all of the ports to be included in the STPD.
Specifies the port or ports to be included in the STPD.
Specifies the ports should be configured as tagged.
Specifies the ports should be configured as untagged.
Specifies an STPD name on the switch.
Specifies the STP encapsulation mode of operation to be 802.1d.
Specifies the STP encapsulation mode of operation to be EMISTP.
Specifies the STP encapsulation mode of operation to be PVST+.
mode.
dot1.d
mode.
emistp
command. To create an STP domain, use the
create vlan create stpd
ExtremeWare XOS 11.5 Command Reference Guide